Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Reference Physical iProperties In Parameter Equati

Thread starter Starker
Start date May 5, 2023

Status: Not open for further replies.

May 5, 2023

Starker

Mechanical

I need to calculate the mass offset of an assembly relative to an axis. How do I reference an iProperty > Physical (Mass, X, Y, etc) in a parameter equation?

I tried iProperties.mass, iProperties.Value("Physical", "Mass"), and just <mass> and had no luck. I didn't find any comprehensive documentation on Parameter syntax, but I'm still looking.