Pack and go does not include drawings?

[aroundhere]

Sorry if this has been discussed. Im trying to pack and go, selecting "include drawings". For some reason it is not selecting the drawings, only parts and assy's. any ideas?

 

[rockguy]

Are the drawings in the same location as the parts and assemblies?

Did you set-up your search locations in SW Explorer?

Rob Rodriguez CSWP

http://www.axiscadsolutions.com

http://www.robrodriguez.com

http://designsmarter.typepad.com/rob_rodriguez/

Eastern Region SWUGN Representative

http://www.swugn.org

http://www.nvtswug.com

SW 2007 SP 2.0

 

[TheTick]

I have this problem, also. It was working fine for a while then stopped finding drawings (not coincident with any SP's or upgrades).

 

[aroundhere]

I have a folder for each component, that includes the drawing and model. These are all under the same project folder. Pack and go will pull models into it fine, even if they are stashed all over the drive. Just not drawings, even though they are in the same folders as the models.

 

[CorBlimeyLimey]

It's working fine for me and always has ... so far. Currently running SW07-SP4.
All parts, assys and drawings in one folder (no sub-folders involved) but components drawn in from other project folders and libraries.

 

[fcsuper]

May I recommend contacting your VAR about this then?

Matt
CAD Engineer/ECN Analyst
Silicon Valley, CA
sw.fcsuper.com
Co-moderator of Solidworks Yahoo! Group

 

[crjones]

This may be a silly question but did you check the box that says you want the drawings? I forgot at first.

 

[sldwkmin]

In order for Pack and Go to attach drawing files they must be in the same directory and have the same name as the model.

Cole M
CSWP, CSWST, CSWI, CPDM
SW06
SW07
HP XW4300, 3.4g proc, 2.5g RAM, ATI Fire GL 3100