Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

opening and flange dimension of a composite vessel

Status
Not open for further replies.
alleak

alleak

Mechanical
Sep 27, 2005
34
Is there any standard for opening and flange dimension of a composite pressure vessel with nonmetalic liner.

Cheers

alleak
 
Status
Not open for further replies.

Similar threads

mechengineer
  • Question
Variant of reverse flange design
Replies
10
Views
4K
TGS4
TGS4
M
  • Question
R Stamping a non-U Stamped Pressure Vessel
Replies
2
Views
4K
jt1234
jt1234
Ronak_Patel
  • Question
commercial software for design of pressure vessel and heat exchanger according to ASME SEC ||| for nuclear application.
Replies
1
Views
4K
MJCronin
MJCronin
hdbcsteve
  • Locked
  • Question
Flange calculations in Low Pressure Vessel calculation
Replies
12
Views
1K
georgeverghese
georgeverghese
A8yssUK
  • Question
High pressure "vessel" inside a vacuum chamber.
Replies
6
Views
2K
EdStainless
EdStainless

Part and Inventory Search

Sponsor

Back
Top Bottom