Only 5 events available in NX User Defined Event (UDE) dialog box

[gnvk]

Hello everyone,

I used Start and End events in NX before. Recently, we switched to NX9 and when I open the UDE dialog box, I only see 5 available events: GOTO, FROM, GOHOME, Spindle and Toolchange markers.

I have uploaded a screen capture here:

http://postimg.org/image/iovhe7mhb/

If you can figure it out, can someone tell me why I am able to see only the 5 above events as available?

Thanks!
gnv

 

[gnvk]

I was able to figure it out. Just so there is a solution if someone is searching in future, I had to reset configuration preferences by going to Preferences-->Manufacturing.