Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Offset mesh in APDL

Status
Not open for further replies.
cocodrillo1

cocodrillo1

Mechanical
Joined
Jun 13, 2009
Messages
6
Location
PL
Dear Users

I have surfaces with a mesh. I would like to get mesh on the offset surfaces (similar as on the example from with the same number of nodes.
Protrude_Mesh_Offset_EX3_kbamvz.png


How to do it in APDL?
My surfaces:

2018-04-12_210035_hqfl7s.jpg



Thank you, best regards.
 
Status
Not open for further replies.

Similar threads

A
generating mesh
Replies
2
Views
7K
Ahmad_f88
A
H
  • Locked
  • Question Question
Plasticity behaviour is not being computed in a non-linear analysis in ANSYS Mechanical APDL 2024 r2
Replies
0
Views
2K
hmsilva
H
rcbsimoes
  • Locked
  • Question Question
Shared Faces in Ansys APDL
Replies
0
Views
565
rcbsimoes
rcbsimoes
rcbsimoes
  • Locked
  • Question Question
ansys apdl, etab, max per row
Replies
1
Views
804
rcbsimoes
rcbsimoes
andradesilva
  • Locked
  • Question Question
modal analysis in ANSYS Mechanical APDL 2020 R2: How to see graphical results without mesh/elements
Replies
1
Views
914
NRP99
NRP99

Part and Inventory Search

Sponsor

Back
Top