Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Oce 9400 Dual Roll Plotter and Microstation?

Status
Not open for further replies.

tlisley

Civil/Environmental
May 20, 2002
2
US
Does anyone know of a driver or way to choose which roll to use in an Oce 9400 plotter? Our plotter has both bond and mylar loaded in it at one time. I can't find anything on this anywhere. Thanks in advance for all of your helpful insight.
 
Replies continue below

Recommended for you

When you bring up your Oce Plot Director, you will notice tabs on the right hand side. Click on the "Media" tab. It should say "AutoRoll" in the box under Paper feed. If you click on the arrow tab next to it, you should see "Roll 1" and "Roll 2". This is where you can make your choice between bond and mylar. Hope this helps you. [bigsmile]
 
debi,

Thanks for the info. I found other info that lets me do this inside of Microstation without having to use Plot Director. I appreciate your taking the time to answer. Have a great day.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top