Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Nylon patch on threads 2
- Thread starter sbrog
- Start date
-
1
- #2
-
1
- #3
Good suggestion from Mint. Another is to refer to standards from the Industrial Fasteners Institute, such as IFI-100, 101, 107, 545, etc.
The above are good, this or similar has come up before, I think someone may have even given the link to the mil std (which is how we used to call it up at a previous employer).
If not in this fora look in Welding, Bonding & Fastener engineering
KENAT,
Have you reminded yourself of faq731-376 recently, or taken a look at posting policies: What is Engineering anyway: faq1088-1484
If not in this fora look in Welding, Bonding & Fastener engineering
KENAT,
Have you reminded yourself of faq731-376 recently, or taken a look at posting policies: What is Engineering anyway: faq1088-1484
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question