Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX9 Toolbars 8
- Thread starter TomMtz
- Start date
JohnRBaker
Mechanical
But is it reasonable that you would have all the tabs enabled at once or that you'd run with that small of a window? Besides, you could create multiple 'Roles', each with it's own set of 'tabs' for when you're running at a smaller than normal window. I used to do that with older versions of NX, having setup a 'Role' for when running NX with a projector so that no toolbar icons would get removed when you went from full resolution down to 1280 x 1024, something which is NOT an issue with NX 9.0 since there are no fixed-length toolbars.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
offtopic, but since it's a lively discussion, i'll just ask it here:
JBaker, has the steel framing (standard structural members) been improved in the new version of nx? (i.e. skeleton + library geometry instead of extrude, like the tubing/ wiring)
if not, any idea when? that's quite an important feature when designing support equipment for assembly etc.
JBaker, has the steel framing (standard structural members) been improved in the new version of nx? (i.e. skeleton + library geometry instead of extrude, like the tubing/ wiring)
if not, any idea when? that's quite an important feature when designing support equipment for assembly etc.
HercalloY
Mechanical
- Oct 9, 2007
- 95
loki3000,
I had a discussion with John about this a while ago and he expressed that it was something they were looking at. I was hoping to have seen something by now but alas, no show. Its one feature i can't understand why it hasn't been implemented (plus i cant wait to see how the NX guys do it... it should be a very deep featured frame generating/cutlist creating beast!).
Any further news John?
I had a discussion with John about this a while ago and he expressed that it was something they were looking at. I was hoping to have seen something by now but alas, no show. Its one feature i can't understand why it hasn't been implemented (plus i cant wait to see how the NX guys do it... it should be a very deep featured frame generating/cutlist creating beast!).
Any further news John?
JohnRBaker
Mechanical
I can't really answer that as it's not an area that I spend any time with. That being said, there are some new tools specifically being developed for modeling the structural members being created when doing ship design.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Status
Similar threads
- Locked
- Question