Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX9 drafting improvement

Status
Not open for further replies.
cubalibre000

cubalibre000

Mechanical
Joined
Jan 27, 2006
Messages
1,070
Location
IT
I've seen in the NX9 Siemens PLM presentation, that the user dimension an hole with center mark and the dimension start at the end of the center mark. Again I've seen that the user dimension with intellignet dimension some point of the drawing and the dimension are addedd in series and after can change in parallel.
I can't replicate this interesting enhancement.


Thank you...

Using NX 8 and TC9.1
 
Status
Not open for further replies.

Similar threads

Nahid Mubin
  • Question Question
Standard Practice for Drafting in NX
Replies
3
Views
9K
GigaManf
G
Kenja824
  • Question Question
Model Items Selectable in Drafting View?
Replies
5
Views
692
Kenja824
Kenja824
Carbonated
  • Question Question
NX Drafting : Impossible to use "I" as label
Replies
2
Views
10K
SDETERS
SDETERS
hmichel
  • Question Question
NX2312 Sketcher and Drafting - Approximate Dimension Symbol
Replies
7
Views
4K
SDETERS
SDETERS
3dr
  • Locked
  • Question Question
Drafting Files with mixed units failure, NX11
Replies
3
Views
1K
Toost
Toost

Part and Inventory Search

Sponsor

Back
Top