Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX9.0 Angular Dimension won't stay in proper position. help?

Status
Not open for further replies.

tcmain47

Automotive
Joined
Apr 23, 2012
Messages
32
Location
US
I am trying to put in an angular dimension, I turn off the Automatic Orientation before placing the dimension. I also can see the dimension as I want it without having to use the alternate positing, but if I move my cursor just a bit it jumps out to another angle and won't give me an option for the desired angle I am looking for.
 
Could you provide at least a picture of what you're attempting to dimension? A video capture show this behavior would be better yet.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top