carlharr
Mechanical
- Mar 20, 2012
- 389
Hello,
I'm struggling with something wonder if anyone can help.
I'm creating a range of adaptors and connectors, and I need to include routing ports with a positive engagement - distance the male connector sits inside the female adaptor.
Unfortunately, positive engagement doesn't seem to be working, instead the two faces with routing ports on touch each other.
If I change the engagement to a negative value, then it works fine and leaves a gap.
So does anyone know why the positive engagement isn't working.
To demonstrate, I've created a simple assembly including an adaptor, and two connectors one with positive, one with negative engagement.
Any help would be greatly appreciated.
NX 8.5 with TC 8.3
I'm struggling with something wonder if anyone can help.
I'm creating a range of adaptors and connectors, and I need to include routing ports with a positive engagement - distance the male connector sits inside the female adaptor.
Unfortunately, positive engagement doesn't seem to be working, instead the two faces with routing ports on touch each other.
If I change the engagement to a negative value, then it works fine and leaves a gap.
So does anyone know why the positive engagement isn't working.
To demonstrate, I've created a simple assembly including an adaptor, and two connectors one with positive, one with negative engagement.
Any help would be greatly appreciated.
NX 8.5 with TC 8.3
