Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX8.5 Part file history - unusual program listed

Status
Not open for further replies.
biker10

biker10

Aerospace
Joined
May 27, 2010
Messages
13
Location
SE
When I look at part file history I would normally expect to see messages like this under Program column
Part renamed from
STEP203TOUG
Refile Part

Could anyone explain what this type of message is

NX 8.5.3.3<!<AP203PKG>!>
 
Sort by date Sort by votes
The part was imported using the STEP AP203 default template.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

A
  • Locked
  • Question Question
Filling Internal Volume Of Part With No Model History
Replies
5
Views
4K
cowski
cowski
Aredybar
  • Locked
  • Question Question
NX mirror part with all history/features included
Replies
1
Views
663
Toost
Toost
nyang
  • Question Question
Moving body from part back to assembly level part
Replies
3
Views
9K
Toost
Toost
A
  • Locked
  • Question Question
Has anyone attempted to use Animation Designer and Part Families on the same file?
Replies
1
Views
3K
Kenja824
Kenja824
swale2
  • Question Question
correct reuse file location.
Replies
4
Views
789
Toost
Toost

Part and Inventory Search

Sponsor

Back
Top