NX8.5 datum plane

[jerry1423]

I am trying to do something incredibly simple here.
I am trying to created to inferred datum from from another datum plane at a distance (at a cylinder centerline), but it defaults to 90 degrees from the initial datum plane, so when I try to change the 90 to zero degrees the datum plane is still placed at 90 degrees, and it seems like I cannot change it.
So how can I change the default from 90 degrees to zero degrees?

This is so dang frustrating.

 

[JohnRBaker]

Not sure what it is that you're trying to do. Could you at least provide a picture of where you're at when you try to add that last Datum Plane?

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.