Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX5 No advanced simulation results anymore 1

Status
Not open for further replies.
HAJS

HAJS

Mechanical
Nov 21, 2008
8
Hello,

I cannot get any advanced simulation results anymore. When solving a case the Analysis Job Monitor goes in a few seconds to "completed", but the are no results and also the results button is not appearing.

Is this happened to anyone before? How do we solve this?

Regards,
Henk
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

H
  • Question
NX Flow: Results generator error for Tecplot results
Replies
0
Views
2K
Herwig
H
A
  • Question
Filling Internal Volume Of Part With No Model History
Replies
5
Views
4K
cowski
cowski
SSO Contractor
  • Question
Distance Measure within an active command i.e., Extrude, Pattern etc. is no longer associative?
Replies
4
Views
4K
jimiherf
jimiherf
jjvcjjvc
  • Locked
  • Question
unigraphics 2312 igs files import forces model to update for no reason
Replies
2
Views
1K
jjvcjjvc
jjvcjjvc
jjvcjjvc
  • Locked
unigraphics 2312 igs files import forces model to update for no reason
Replies
0
Views
781
jjvcjjvc
jjvcjjvc

Part and Inventory Search

Sponsor

Back
Top Bottom