NX1892: Is there any document on comparison on Product Interface and Wave Geometry Linker

[CAD Application Support]

Hi ,

Is there any document which gives the comparison between Product Interface and Wave Geometry Linker on what are the benefits, when to use which etc..

 

[PSI-CAD]

Hi,

Product Interface is a only process to limit what it is permitted as a wave geometry to link in a part

If you set a face for example as product interface in a part, it will not possible to select other geometry in wave geometry linker when this part is in an assembly

Regards
Didier Psaltopoulos

http://www.psi-cad.fr