NX10 FEM post processing. Where are the minimum and maximum markers??

[obe0009]

Hello,

I am using NX10 FEM advanced simulation.
In post processing I was looking for the MIN and MAX markers (I work with NX75)
button. I could not find them only the min amx markers for a graph.

Anyone any ideas?

Regards,

Olaf

 

[BlasMolero]

Dear obe0009,
Yes, in fact, in old versions was more "at hand".
In NX10 You can activate the maximum & minimum annotations in the POST VIEW, se picture:

Best regards,
Blas.

~~~~~~~~~~~~~~~~~~~~~~
Blas Molero Hidalgo
Ingeniero Industrial
Director

IBERISA
48004 BILBAO (SPAIN)
WEB:

http://www.iberisa.com

Blog de FEMAP & NX Nastran:

http://iberisa.wordpress.com/

 

[obe0009]

Hello Blas,

Thanks, I played around in the post view but did not see/expect it to be there.

Regards,

Olaf