Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX symbols
- Thread starter JHG1981
- Start date
JohnRBaker
Mechanical
In what context are you seeing these sysmbols? If you hover the cursor over them, are you getting any feedback as to what they might be used for?
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #3
- Thread starter
- #4
Team,
Honestly it not worth alot of research... I simply found it interesting, I quickly noticed in the screen shot I was sent that there wasn't many icons on the person's screen so it made me think it was a commonly used command. Its probably a NX module that I don't have and that person only uses for one thing.
Honestly it not worth alot of research... I simply found it interesting, I quickly noticed in the screen shot I was sent that there wasn't many icons on the person's screen so it made me think it was a commonly used command. Its probably a NX module that I don't have and that person only uses for one thing.
It may be that someone created custom icons for an existing or custom NX function. If this is the case, only the person that sent you the screenshot would be able to tell you for sure...
www.nxjournaling.com
www.nxjournaling.com
- Thread starter
- #6
- Status
