Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX License time-out
- Thread starter nag57
- Start date
Has NX implemented the TIMEOUT feature in FlexNet? Haven't followed NX licensing for a few years, but when TIMEOUT was introduced, UG2/NX did not support its use.
I don't see anything in the option file options that will do what you want. I am guessing you have more users than licenses? Not sure if gROUP will provide some of what you want.
Check out the FlexNet Licensing End User Guide for details of the options.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
I don't see anything in the option file options that will do what you want. I am guessing you have more users than licenses? Not sure if gROUP will provide some of what you want.
Check out the FlexNet Licensing End User Guide for details of the options.
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli
MessersmithS82
Aerospace
NX doesn't support it but has mentioned to me when I've called GTAC that you can do this through the options file using the Acresso FLEXLM. I haven't experimented with it myself yet, but am needed to accomoplish the same task as you are wanting to do with doing a timeout of licenses and blocking some of CAD users from being allowed to pull the CAM bundles.
- Status
