Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX DRAFTING ASSOCIATIVITY
- Thread starter TASKAHEAD
- Start date
Balloon/note leaders are usually associated to an object, but the balloon/note itself can also be associated to other annotations or geometry. If you reattach the leader(s) and the balloon/note still shows as 'retained' try this:
Edit -> annotation -> origin, pick the balloon/note and press OK. This should reset the balloon/note origin to be set at the current position without any associations.
You didn't mention the version of NX you are using. The menu location should work for most recent versions with the possible exception of NX 9.
www.nxjournaling.com
Edit -> annotation -> origin, pick the balloon/note and press OK. This should reset the balloon/note origin to be set at the current position without any associations.
You didn't mention the version of NX you are using. The menu location should work for most recent versions with the possible exception of NX 9.
www.nxjournaling.com
Yes, sometimes.
For me it can be quickest just to delete the existing leader and add a new one.
It is possible that the note became unassociated because it was (unknowingly) linked to either the view itself or an entity in the view that changed with the geometry change.
edit (pull down on NX7.5) -> annotation -> origin -> unchaeck "associative"
For me it can be quickest just to delete the existing leader and add a new one.
It is possible that the note became unassociated because it was (unknowingly) linked to either the view itself or an entity in the view that changed with the geometry change.
edit (pull down on NX7.5) -> annotation -> origin -> unchaeck "associative"
- Status
