Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX CAM - machine simulation
- Thread starter ma1ster
- Start date
This would be a good place to start
also there is a pdf in your c drive in the mach directory. I think sample folder, but not sure.
Telling you how to use it is way too involved for a forum. These resources should get you started so you can ask questions.
also there is a pdf in your c drive in the mach directory. I think sample folder, but not sure.
Telling you how to use it is way too involved for a forum. These resources should get you started so you can ask questions.
- Status
