Is there a way in Pattern Geometry to select multiple target points without having to create a sketch? In the previous version using Instance Geometry, you could select target points anywhere you liked without the need for creating a planar sketch and placing points. Please tell me this feature hasn't been broken.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX 9.0 Pattern Geometry Functionality
- Thread starter ajibcj
- Start date
JohnRBaker
Mechanical
I have NO problems whatsoever selecting multiple 'To' points (either one-at-a-time or by area select), which were NOT part of a sketch, when using 'Pattern Geometry' and the Layout method 'General'.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #3
- Thread starter
- #4
- Status
