NX 8 Face/Edge Blend Problems

[ckirk]

Hi all,

I would like to create a fillet sized at 0.07in with the two faces shown in the attached image. It's a weird geometry and right now I am only able to get smaller ones using either Face Blend or Edge Blend. I have attached the part file for reference.

Any pointers or tips would be greatly appreciated.

Thanks,

ckirk

 

[cowski]

There is some pretty ugly wrinkling in your surfaces. Until you get that smoothed out, I don't think you'll get the blend you want.

www.nxjournaling.com