NX 10

[LayKanae]

Hello everyone!

I guess the majority already have some knowledge about the launch of NX10!

I'm excited because I saw that this new version has some improvements in 2D,

However... Does anyone know if it has improved the creation of drawing templates?

 

[jerry1423]

what type of improvements are you looking for?

 

[LayKanae]

Faster and easier ways of doing custom templates

So far I have applied different methods which are usually long and impractical, besides having to make templates for each sheet type, because I when resize the sheet... the formatting is lost

I've seen some friends perform the same templates in Inventor and make it so much easier

 

[jerry1423]

Do you use TeamCenter?

 

[Arkance/PhoeNX]

In NX10, the title block will reposition automatically when the drawing border is changed, so if the sheet size changes, the title block will reposition.
From that I can't see why you can't make only one template for all possible sheets sizes.


Anthony Galante
Senior Support Engineer


NX3 to NX10 with almost every MR (21versions)

 

[LayKanae]

Hello Jerry1423

No, we do not use Teamcenter

 

[LayKanae]

Hello Phoenx

We designed a template per sheet because the title block was not kept in position when resizing ...

In addition, block size title must change according to the size of sheet