Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
number of decimal places in information window 1
- Thread starter uwam2ie
- Start date
-
1
- #2
JohnRBaker
Mechanical
It was changed in NX 8.0 because it was incorrect in previous versions of NX. Even if you had set it to 16, the maximum number of decimal places displayed in a listing window was 14.
So the only real change was correcting the Customer Default dialog.
BTW, even in NX 7.5, if you had gone to...
Preferences -> User Interface -> General
...and tried to enter either 15 or 16 in the 'Information Window' entry for 'Displayed Decimal Places', it would have reverted to 14 anyway, since that was the actual maximum.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
So the only real change was correcting the Customer Default dialog.
BTW, even in NX 7.5, if you had gone to...
Preferences -> User Interface -> General
...and tried to enter either 15 or 16 in the 'Information Window' entry for 'Displayed Decimal Places', it would have reverted to 14 anyway, since that was the actual maximum.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #3
- Status
Similar threads
