Norsok Standard Weldolet

[Deji76]

Hello,
I am working on a project which I have been asked to use Norsok Standard Weldolet. I am not familiar with these. Any pointer would help.

 

[pennpiper]

Maybe the "Norsok Standard Weld-o-Let" is the WFI/Bonny Forge Weld-o-Let.

If it was the Client who "asked" for this then ask them to supply the Name, address, and phone number of their supplier.

prognosis: Lead or Lag

 

[SJones]

It could be a weldolet meeting the requirements of an appropriate datasheet in NORSOK M-630.

Steve Jones
Corrosion Management Consultant

http://www.linkedin.com/pub/8/83b/b04

All answers are personal opinions only and are in no way connected with any employer.

 

[Deji76]

Steve,
The specification references EDS NOL1 which I am unable to find in M-630.

 

[LittleInch]

For some reason the EDS NOL1 wasn't included in M-630, but if you go to the website

http://www.standard.no/en/Sectors/Petroleum/NORSOK-Standard-Categories/L-Piping--Layout/L-0012/,

download the L-001 zip file for Rev 3, in the EDS folder there is a single page for file NOL1 which refers to the 'o'let design.

My motto: Learn something new every day

Also: There's usually a good reason why everyone does it that way

 

[Deji76]

@LittleInch,
Thanks I have seen it.
I can't really see any difference with standard MSS SP olets