I've got a situation where someone created a project length Proposed Right-Of-Way file and from that, offset the Limit Of Disturbance line. I need to create shapes between the two lines (per property) .... usually a piece of cake task, right? Well, it turns out that all these lines are NONSNAPPABLE. Is there a key-in or mdl that will allow me to change the enire file to SNAPPABLE without having to do it one line at a time? I'm using Microstation/J.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
nonsnappable to snappable
- Thread starter debi
- Start date
vsiccclubchamp
Civil/Environmental
YOU CAN TRY TO MAKE A SELECTION SET OUT OF THE ELEMENTS IN QUESTION. THEN GO TO ANALYZE ELEMENT. CHANGE THE PROPERTIES TO SNAPPABLE. THEN HIT NEXT AND IT WILL GO THE NEXT ELEMENT IN THE SELECTION SET AND CHANGE IT AS WELL. CONTINUE TIL THE END OF THE SELECTION SET.
GOOD LUCK
GOOD LUCK
- Status
Similar threads
- Locked
- Question
