No section part in view

[cubalibre000]

Hi,
I decided to no section a pin in a view with the command 'Section in view'.
The command work fine, but the crossatch remain.
I deleted the crossatch.
After that I decided to section the pin so with the command 'Section in view' I resectioned the pin, but the crossatch is not created.
I need to add the crossatch manually ?

Thank you...

Using NX 8 and TC9.1

 

[cubalibre000]

Hi,
here the result after de-section and re-section the pin.

Thank you...

Using NX 8 and TC9.1

 

[Bwsh]

When the original nut is sectioned by itself, it doesn't show the cross-hatching lines.
However if the original nut is exported to parasolid file and re-imported into NX, and then do the sectioning again, it does show the cross-hatching lines. See attached snapshots. It seems like the original nut part file has to change some attribute setting in order to have it to display the cross-hatching lines.

 

[cubalibre000]

Sorry Bwsh, you don't have understand the question.
The problem is not on the nut but on the pin.
Please read well the topic.

Thank you...

Using NX 8 and TC9.1

 

[ewh]

In NX 6, it works this way:
Edit -> View -> Section In View
Pick the view, then pick the Select Object icon in the Section In View menu.
Select object -> OK
Regenerate view

Pin should now be sectioned.

“Know the rules well, so you can break them effectively.”
-Dalai Lama XIV

 

[cubalibre000]

Regenerate view was the missed operation at the final.
Thank you

Thank you...

Using NX 8 and TC9.1