Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

No results displayed for large analysis

Status
Not open for further replies.
hemishark

hemishark

Mechanical
Joined
Nov 25, 2003
Messages
1
Location
US
I'm having trouble getting results from a large model I'm working on. Basically, I run the analysis, it runs for a good 20 to 30 mins and no results are displayed. The model pops up in Superview with the blue shading as if the stresses were "0" but there are no results. I have had some DOF and geometry errors that pop up, but they have been resolved.

I've contacted Tech Support but no real help from them yet. Anybody encounter these issues before?

 
Status
Not open for further replies.

Similar threads

Boghi1990
  • Locked
  • Question Question
Circumferential, Radial & Axial Stresses , Output Results Algor Autodesk Mechanical Simulation
Replies
1
Views
830
barrti
barrti
Boghi1990
  • Locked
  • Question Question
Thermal Stress Analysis Model Constraints
Replies
0
Views
766
Boghi1990
Boghi1990
Boghi1990
  • Locked
  • Question Question
Main Steam Lines Thermal Stress Analysis
Replies
0
Views
849
Boghi1990
Boghi1990
BjornF
  • Locked
  • Question Question
General ideas for large deformation contact analysis
Replies
0
Views
193
BjornF
BjornF
barrti
  • Locked
  • Question Question
Looking for opinions on the use of Autodesk Simulation mechanical (ASM) for steel plate structures
Replies
12
Views
1K
barrti
barrti

Part and Inventory Search

Sponsor

Back
Top