Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

no facets

Status
Not open for further replies.
neema1984

neema1984

Marine/Ocean
Joined
Jan 29, 2010
Messages
12
Location
US
hey, I am getting

"surface -- has no facets" several times when analysing. What may be the cause of it... any comments please
 
Sort by date Sort by votes
It could be some poor imported geometry, usually a sliver surface. Often, you can just delete the problematic surface and run the analysis.

tg
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

N
  • Question Question
Nonlinear Buckling Analysis after Pretensioning (Wrinkling Study – Patran/Nastran SOL 400)
Replies
0
Views
5K
Nic0
N
Gabrieldondeu
  • Locked
  • Question Question
Freq response (SOL 111) of a composite model on Nastran: no stress calculated in pcomp elements
Replies
1
Views
692
dmapguru
dmapguru
catalina29
  • Locked
  • Question Question
Nastran SOL400 normal modes analysis with touching contact
Replies
1
Views
3K
karachun
karachun
jmarkus
  • Locked
  • Question Question
Nastran SOL 106 - Bi-/Tri-Linear Stress Strain result from Non-linear Material curve
Replies
8
Views
2K
tim1958
tim1958
MarianaM43
  • Locked
  • Question Question
Structural Simulation - No results are found
Replies
1
Views
623
MarianaM43
MarianaM43

Part and Inventory Search

Sponsor

Back
Top