Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

no facets

Status
Not open for further replies.
neema1984

neema1984

Marine/Ocean
Jan 29, 2010
12
hey, I am getting

"surface -- has no facets" several times when analysing. What may be the cause of it... any comments please
 
Replies continue below

Recommended for you

Sort by date Sort by votes
It could be some poor imported geometry, usually a sliver surface. Often, you can just delete the problematic surface and run the analysis.

tg
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Gabrieldondeu
  • Locked
  • Question
Freq response (SOL 111) of a composite model on Nastran: no stress calculated in pcomp elements
Replies
1
Views
504
dmapguru
dmapguru
catalina29
  • Locked
  • Question
Nastran SOL400 normal modes analysis with touching contact
Replies
1
Views
2K
karachun
karachun
jmarkus
  • Locked
  • Question
Nastran SOL 106 - Bi-/Tri-Linear Stress Strain result from Non-linear Material curve 1
Replies
8
Views
1K
tim1958
tim1958
MarianaM43
  • Locked
  • Question
Structural Simulation - No results are found
Replies
1
Views
483
MarianaM43
MarianaM43
Emi.Cor
  • Locked
  • Question
Contact not Working on Nastran 2017 1
Replies
8
Views
1K
Emi.Cor
Emi.Cor

Part and Inventory Search

Sponsor

Back
Top Bottom