Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

New Y14.5-2009 & Y14.8 symbols for Solidworks 2009?

Status
Not open for further replies.

ptruitt

Mechanical
Nov 13, 2007
233
I want to use the Y14.5-2009 4.24.6 "Movable Datum Target Symbol" and the Y14.8-2009 3.14.2 "All Over This Side of the Parting Line" symbol with my 2009 version of Solidworks. I guess I could create a block, but maybe there is a better way. Does anyone know if this is doable? If so, please point me in the right direction.

Peter Truitt
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor