Aug 4, 2007 #1 BobWescott Industrial Aug 4, 2007 1 I am an experienced CAD/CAM programmer, but am just starting out with unigraphics, is there any training material available and what would be a good starter point.
I am an experienced CAD/CAM programmer, but am just starting out with unigraphics, is there any training material available and what would be a good starter point.
Aug 4, 2007 #2 JohnRBaker Mechanical Jun 1, 2006 37,222 Contact your local UGS sales rep and they can help set you up with severaql different options in self-paced learning. http://training.ugs.com/self-paced/index.shtml John R. Baker, P.E. Product 'Evangelist' UGS NX Product Line SIEMENS UGS PLM Software Cypress, CA http://www.siemens.com/ugshttp://www.plmworld.org/museum/ Upvote 0 Downvote
Contact your local UGS sales rep and they can help set you up with severaql different options in self-paced learning. http://training.ugs.com/self-paced/index.shtml John R. Baker, P.E. Product 'Evangelist' UGS NX Product Line SIEMENS UGS PLM Software Cypress, CA http://www.siemens.com/ugshttp://www.plmworld.org/museum/
Aug 6, 2007 #3 marstonm Mechanical Aug 6, 2007 3 If you are just looking for books, Design Visionaries books are very good. Check them out: http://www.designviz.com/publications/books Mike Upvote 0 Downvote
If you are just looking for books, Design Visionaries books are very good. Check them out: http://www.designviz.com/publications/books Mike
Aug 7, 2007 #4 joycejo Aerospace Sep 22, 2006 627 You can get on-line training at http://www.myigetit.comCAD CAM Assemblies Drafting and more. Upvote 0 Downvote
