Hello, I am currently working on an AGV project.
I have created a model using Adams View. Within the ADAMS control setup, I provide torque inputs to the two tires and set up frictional contact and rotational constraints for all tires. However, when I run the simulation, the AGV remains stationary (idling) in its place. I am seeking guidance on how to resolve this issue.
Additionally, I am planning to include magnet simulation in my project.
Do you happen to know which software would be suitable for conducting this type of simulation alongside Adams?
I have created a model using Adams View. Within the ADAMS control setup, I provide torque inputs to the two tires and set up frictional contact and rotational constraints for all tires. However, when I run the simulation, the AGV remains stationary (idling) in its place. I am seeking guidance on how to resolve this issue.
Additionally, I am planning to include magnet simulation in my project.
Do you happen to know which software would be suitable for conducting this type of simulation alongside Adams?
