Move Component

[kr7530]

In NX7.5 we could set our "Snap" distance inside the "Move Component" function when using "Dynamic" and it would maintain that value even after exiting the function and reentering. It would only default back to 0.000 when a new session of NX was started.
However, in NX8.0 it defaults back to a value of 0.000 every time you use the function within the same session of NX. Is there a "Customer Default" we are missing?

Thanks,
Kevin

 

[NXsupport]

Hi Kevin,

is Remember Dialog Memory turned on in the role?

 

[kr7530]

I am sorry but I can't find "Remember Dialog Memory" anywhere. I can find "Save Dialog Memory" but this does not seem to help any. Any addition help would be greatly appreciated.

Thanks,
Kevin

 

[JohnRBaker]

It's working fine in NX 9.0.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.