Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

MOV setting

Status
Not open for further replies.
helpyou

helpyou

Automotive
Joined
Sep 26, 2011
Messages
79
Location
QA
HI

what is the difference in MOV setting configuration between close setting at position limit and torque value.

Thank you
 
Sort by date Sort by votes
There's likely a logical AND function for the two switches: if either trips, the motor stops.

The torque switch can trip before the actuator shaft reaches its limit, whereas the limit switch is a physical position limit.

 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

mforoutanfar
  • Locked
  • Question Question
Pressure gauge movement and bourdon tube dimensions and standards
Replies
3
Views
243
mforoutanfar
mforoutanfar
rasooooo
  • Locked
  • Question Question
measurement of -/+ 4mm axial movemnet with high resolution
Replies
3
Views
214
Skogsgurra
Skogsgurra
emperor84
  • Locked
  • Question Question
Pressure Gauge Movement Dampening
Replies
11
Views
609
glowing
glowing
NGil
  • Locked
  • Question Question
Do you hydrotest a MOV (this one is a ball valve)?
Replies
6
Views
365
JLSeagull
JLSeagull
BobM3
  • Locked
  • Question Question
lasers to check perpendicular movement
Replies
3
Views
264
IRstuff
IRstuff

Part and Inventory Search

Sponsor

Back
Top