Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Motion simulation range

Status
Not open for further replies.
canadianchap

canadianchap

Mechanical
Joined
Aug 1, 2013
Messages
3
Location
CA
I have a specific question about spherical joint (ugs nx 8)

How do I can ofeset a range angles conical motion in spherical joint?
For example in car suspention link... I would like to simulate stewart platform motion which start on rotation input.

thanks for help

 
Status
Not open for further replies.

Similar threads

Chris33777
  • Locked
  • Question Question
Surface Selection in Simulation
Replies
0
Views
214
Chris33777
Chris33777
kar99429
  • Locked
  • Question Question
COntact Set in Dynamic analyis..I-deas simulation
Replies
0
Views
285
kar99429
kar99429
mirza037
  • Locked
  • Helpful tip Helpful tip
Simulation of non-linear thin material in IDEAS for defects
Replies
0
Views
126
mirza037
mirza037
mirza037
  • Locked
  • Question Question
Simulation of non-linear thin material in IDEAS for defects
Replies
2
Views
174
mirza037
mirza037
mcoll
  • Locked
  • Question Question
FEA Simulation .AVI Files
Replies
0
Views
126
mcoll
mcoll

Part and Inventory Search

Sponsor

Back
Top