Service call today, to assist on machine at veneer mill. It's a MONGUZZI machine from Italy. It has MMI for operator to use ( limited as to interface options ). This communicates to ALCAN plc cabinet. Found some electrical issues, loose grounds, broken shield on servo controller. Still having issues with communicating. Anyone deal with this manufacturer before, and possibly lend some technical advice?? Thanks in advance......
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Monguzzi controller / anyone familiar?
- Thread starter lefty51
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question