Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Modelling - Edge Blend - Variable - Radius Change Points

Status
Not open for further replies.

Adeo

Aerospace
Joined
May 21, 2009
Messages
6
Location
DE
Hi all

In NX4....does anyone know if its possible to 'get hold' of the change 'points' at the %Arc Length's originally used to define a variable edge blend?...the aim being to be able to detail dimension to these change points.

At the moment the only way I can see is to create essentially duplicate points on extracted edges before the blend is done and create expressions so the model points 'coincide' with the 'green cube' %Arc Length change points in the Blend operation....any better ideas would be more than welcome! :-D



Adeo
Senior Designer
Aero/Industrial Gas Turbines, Aerostructures, F1, Catia V5 & NX4
 
I really don't think that there is a way to do what you want to do.
What you can to is add points to the model, and use them for your variable blend, and then dimension to those points.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top