Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Modeling the process of sintering in ABAQUS

Thread starter ferro1001
Start date Sep 20, 2005

Status: Not open for further replies.

Sep 20, 2005

ferro1001

Automotive

Hi,

I have to model the process of sintering in a model which has to do with powder metallurgy in a FEM program; I have been told that ABAQUS has a module specially designed for this, is this true?, does anybody know where I can find information about this?

Thanks in advance,

ferro1001