Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Modeling "Composite Beam"/Multiple Shapes in STAAD/VersaFrame

Status
Not open for further replies.
LaurenD

LaurenD

Geotechnical
Jul 12, 2013
1
I need to use VersaFrame, which is similar to STAAD to model two MC18x58 shapes located 6 inches apart with a high strength HSS 12x8x1/2 shape welded on top. I have a load centered on top of the HSS member. The two MC18x58 are simple supported on each end. Does anybody know how to model the HSS on top of the MC's without using a plate? Also, the 12" side of the HSS is horizontal. How do I turn the shape around from the default location?

Thanks!
 
Status
Not open for further replies.

Similar threads

M
  • Question
FEA Adhesive Modeling
Replies
3
Views
5K
milio000
M
G
  • Locked
  • Question
Modelling a post-tensioned stone arch or beam in Strand7
Replies
3
Views
1K
Gigi2000
G
EdwardNigma
  • Question
Mastering FEA: How to Get Through Stage 2 (Developing Good Modeling Techniques)?
Replies
7
Views
4K
rb1957
rb1957
JoeCK
  • Locked
  • Question
Slab to beam connection
Replies
0
Views
562
JoeCK
JoeCK
oharag11
  • Locked
  • Question
Modeling/simulating thermal vias - PCB/Electonic thermal analysis?
Replies
0
Views
640
oharag11
oharag11

Part and Inventory Search

Sponsor

Back
Top Bottom