Modelcheck

[rajeshrs]

Hi,

Could someone give me a brief rundown on what PTC ModelCheck does when it checks models and what kinds of inputs and outputs are there in PTC ModelCheck?

Any help will be appreciated.

 

[ANormand]

I have only used model check when surface modeling. In that case it identifies possible points of failure for solidifying.

 

[rajeshrs]

ANormand

Thanks for your response. I too use Pro/Surfaces quite a bit. Would you happen to know how to configure ModelCheck using the config files?

Thanks in advance

 

[looslib]

Send me a private email as I have a ModelCheck tutorial on how to set it up.

"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli