MMB on tolerances other than position and orientation

[Burunduk]

Per ASME Y14.5-2009, do you consider it acceptable to apply datum features MMB (to allow datum shift) for profile or runout controls? (As a side note - I do realize that for runout, allowing datum shift seems to make little sense functionally but I've seen parts being inspected for runout on a fixed size gauge with small clearance on the diameter, without any negative consequences). Looking briefly through the figures, haven't found an example of MMB for the profile or runout cases.

 

[CheckerHater]

Runout - absolutely NO.

Profile - no problem:

"For every expert there is an equal and opposite expert"
Arthur C. Clarke Profiles of the future

 

[Burunduk]

CH, thanks a lot!
Both points (MMB for runout and profile) got clarified.