arcticcatmatt
Mechanical
How come when your mirror a part thru a plane, none of the hole information goes with it. So, when I try to create a drawing of a mirrored part and use the hole callout, junk.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Mirroring part brings no hole information
- Thread starter arcticcatmatt
- Start date
- Status
- Thread starter
- #21
arcticcatmatt
Mechanical
Everyone fill out a request. Fixing this would save us SO much time here.
We have been mirroring complex parts with a bazillion holes and manually typing in the hole wizard information. Very dangerous practice but we had to as it just called out everything as a thru hole.
We have been mirroring complex parts with a bazillion holes and manually typing in the hole wizard information. Very dangerous practice but we had to as it just called out everything as a thru hole.
- Status
Similar threads
- Question