Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Minimum wall thickness when machining Delrin and PC.

Status
Not open for further replies.
phl73

phl73

Mechanical
Joined
Oct 12, 2005
Messages
1
Location
US
What should the minimum wall thickness of Delrin and PC be when machining. Thanks
 
Sort by date Sort by votes
Your minimum wallstock really depends on your machining process. If you machine one side, then cast it into a "holder", you should easily be able to machine down to at least 1mm (.04").
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

aksim
  • Locked
  • Question Question
Extruding HDPE thin wall tube
Replies
4
Views
833
aksim
aksim
abra87
  • Locked
  • Question Question
thickness of car headlight
Replies
8
Views
1K
dgallup
dgallup
innominata
  • Locked
  • Question Question
Face Seal Fastener Placement and Spacing
Replies
6
Views
2K
DogPAnt
DogPAnt
DogPAnt
  • Locked
  • Question Question
Water sealing problem with epoxy and PVC
Replies
5
Views
1K
DogPAnt
DogPAnt
Azeen
  • Locked
  • Question Question
Mixing virgin and recycled Polypropylene Granules in single use plastic straw extrusion machine
Replies
5
Views
1K
Linda0510
Linda0510

Part and Inventory Search

Sponsor

Back
Top