I'm not sure this is the right forum, but I couldn't find one for MIL Specs. We are dealing with an oxygen filler valve that calls out reliability testing at an Inspection Level II. Which for our lot size, the sample size would be 50. In the previous rev of MIL-PRF-38201D, which is MIL-V-38201C, the Inspection level is S-1, which would be a sample size of 3. Our QAR (government rep) pointed this out and we are in need of some guidance as to how to prove the intent of the document. Any suggestions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
MIL-PRF-38201D 1
- Thread starter rlangdon
- Start date
-
1
- #2
The correct forum for discussion of MIL specifications is Military engineering other topics (forum431).
Best regards,
Matthew Ian Loew
"I don't grow up. In me is the small child of my early days" -- M.C. Escher
Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.
Best regards,
Matthew Ian Loew
"I don't grow up. In me is the small child of my early days" -- M.C. Escher
Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.
- Status
Similar threads
- Locked
- Question
- Question
- Question
