Microstation V8-Getting Angles into Azimuth Mode

[Ositobrujo]

Greetings,

I just changed over to MSV8, I am handling lots of data from TMS and my surveyors. I would like to set the angle to 0 degrees to the top of the viewer and have the degrees increase clockwise, in azimuth mode, like a normal compass. I am stuck with 0 degrees to the right(x-axis) and an increase counter-clockwise. I am new user so I am bit stumped.

Thanks, Terrence

 

[mike80]

Settings>Design file>coordinate readout

This will let you set your coordinate readout to azimuth instead of the default bearing. Also set your accuracy here.



Mike

 

[Ositobrujo]

Thanks Mike, Ter