Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

meshing

Status
Not open for further replies.
yabande

yabande

Mechanical
Joined
Sep 11, 2008
Messages
20
Location
GB
why ansys workbech doen't show the defomred mesh in the graphics interface solution? is there any way to show the deformed mesh caused by load?
 
Sort by date Sort by votes
Is there any idea or thought?

Thanks.
 
Upvote 0 Downvote
Dear

There is the option to show element over an results in the outline display.

Regards
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Vitkacy1989
  • Locked
  • Question Question
Sweep Meshing - simple but hard to achieve
Replies
3
Views
507
ikerg
ikerg
RDelaCourt513
  • Locked
  • Question Question
Ansys - Explicit Dynamics Meshing/Solver help
Replies
2
Views
533
RDelaCourt513
RDelaCourt513
bsquared55848
  • Locked
  • Question Question
Cyclic Symmetry + Meshing -- "cannot find matching topology"
Replies
1
Views
782
bsquared55848
bsquared55848
CDDK
  • Locked
  • Question Question
Workbench meshing automatically updates and increases relevance
Replies
2
Views
228
CDDK
CDDK
victorpbr
  • Locked
  • Question Question
Meshing Pressure Vessel - Tips Needed
Replies
4
Views
546
victorpbr
victorpbr

Part and Inventory Search

Sponsor

Back
Top