Guest
im using V5R6 and meshing a product with various parts
what do i need to do to make sure all parts are meshed - at the moment im having to put clamps on all the parts otherwise i get a singularity error i.e. pivot too small
im sure its a constraint problem but ive tried using contact constraints between the parts and the main clamped part but it doesnt seem to make a difference - Any suggestions would be much appreciated!!!
what do i need to do to make sure all parts are meshed - at the moment im having to put clamps on all the parts otherwise i get a singularity error i.e. pivot too small
im sure its a constraint problem but ive tried using contact constraints between the parts and the main clamped part but it doesnt seem to make a difference - Any suggestions would be much appreciated!!!
