Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

mesh in the group

Status
Not open for further replies.

vyaghoubi

Structural
Joined
Nov 27, 2013
Messages
1
Location
SE
hello everyone,

I am trying to mesh the parts in different groups, but when i do that i can see an image of the mesh in another group as well, I'd like to know if anyone can help me in this issue.

thanks a lot
 
i suspect you might get better response in the FeMap forum, under "engineering computer programs".

when making your mesh, how are you defining the geometry ? by type ? by group ? (if by group, then it's funny it's meshing outside the group ??)

Quando Omni Flunkus Moritati
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top