mesh and mesh control issues

[ajroc]

Hello,

I am having the following problems with meshing an assembly in cosmosworks 2005:
1. When viewing failure diagnostics, while reviewing the part that failed, cosmos will point me to an edge on a different part.

2. After applying a control to a part, and leaving the global mesh settings the same, parts that previously meshed before no longer mesh.

What could be going wrong here?

Thanks in Advance,
Adrian

 

[ctopher]

You may want to ask in the CosmosWorks forum.

Chris
Systems Analyst, I.S.
SolidWorks 06 4.1/PDMWorks 06
AutoCAD 06
ctopher's home (updated 06-21-06)

 

[ajroc]

thanks - I will post over there.